C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

dac_trigger.SOFT_RESET = 10; // 当设置为保留码A(1010)时，该位复位设备到默认状态。这些位是自我复位的。 dac_trigger.LDAC = 0; // 将此位设置为1，以同步模式同步加载DAC，此位是自复位。 dac_send_data(DACx0501_TRIGGER, dac_trigger.Trigger); dac_sync.DAC_SYNC_EN ...

设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

I'm in need of a synchronous (for high efficiency) DC-DC buck converter with a 120V (max) input and 3V output. Is it possible to use TPS40041 where VDD is initially generated from 120V through a ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

Referring to the list of clock identifiers in the link and also refer the clock summary taken from /sys/kernel/debug/clk ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...