C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I am trying to install PSPICE for TI (2021.1), but I am having difficulty. I downloaded the installer, PSpice-For-TI_setup.exe, and when I ran this application, I only saw a splash screen for a few ...

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I need to call a CC3000 firmware method using a Clock or Timer. Unfortunately when I do this, I get the following error message. ti.sysbios.knl.Semaphore: line 207 ...

I've been trying to load firmware from PC to TUSB3210KBD-REV 3 EVM using the Apploader but haven't see success so far. The OS on my PC is Windows XP (32-bit). The EEPROM has been removed from the ...

We use the MMWCAS-DSP-EVM with the MMWCAS-RF-EVM (AWR1243 cascaded 4-chip radar module). Using MATLAB software, we plot range-Doppler maps by processing the captured data stored in bin files (outputs ...

I followed the porting guide from mmWaveLink docs and managed to run mmWaveDFP on my FPGA. I am running mmWaveLink_SingleChip_NonOS_Example and using SPI communication. MMWL_powerOnMaster and ...

I have received a .DAT file from the mmWave Visualizer. How can I open/analyze this file using Matlab? I am trying to get the points information, is there has matlab or python code?

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...