Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

I am running a tcp server using the enet_lwip example provided for the F28388D board. I am using a sample application code for TCP Server, this code is tcpechoserver. This code works fine, it reflects ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

Is the processing method for converting data into voltage values the same for single ended input and differential input? When differential input is used, the following method is used for data ...